來源：http://www.skyequiltedcards.com 發布時間：2022-06-30 14:59:39
Aluminum thermal insulation decorative board is a popular tomb wall decorative material in the current market, which can be processed and formed at one time in the factory without secondary processing at the construction site. It is easy to install. The installation can be completed with corner code, keel and other accessories without any cement sand. The aluminum insulation decorative board can also be 100% recycled. In the process of installation and use, it is inevitable to encounter the wear and scratch on the surface of aluminum insulation decorative board. Then, how should this problem be handled? Generally, there are two kinds of scratch wear on the surface of aluminum insulation decorative plate:
1. The friction between the protective film on the surface of the aluminum insulation decorative plate and the coating causes the protective film to wear and stick to the aluminum plate
2. The paint on the surface of the aluminum plate thermal insulation decorative plate falls off and the aluminum alloy substrate is exposed
In case of the above two situations, it shall be handled separately:
The first kind can be wiped with gel remover to remove black spots. The second kind of aluminum alloy substrate is very serious. The periphery of the worn and scratched surface can be cleaned with diluent, and then repaired. When repairing, be sure to pay attention to the surrounding pollution and repair with a soft hand brush.
During the installation or handling of the aluminum insulation decorative board, it is better to wear gloves. It should also be noted that sharp objects should not rub against the surface of the wrong veneer. When placing the aluminum insulation decorative board, it should be handled with care, which can greatly reduce the wear and abrasion of the aluminum insulation decorative board.
The aluminum plate manufacturer recommends that you wear gloves as much as possible when installing and using aluminum plates. When using sharp tools, be careful not to touch the surface of the aluminum veneer. At the same time, you can also consult the customer service of aluminum veneer before installation to get some suggestions.
The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.skyequiltedcards.com And consult our staff, will serve you wholeheartedly.